several stock acrylic and glitter color

Glitter background on this magnet is bright and attractive at a distance – perfect for a special stay. Eliminate vacation pictures on several stock acrylic and glitter color different use of the variety. Attach a magnet to the outside of a gift bi-repositionable adhesive tape.
Supplies
• Craft Black Ink
• scrap paper
• Stamp (1 1 / 2 “Recommended graphics)
• 2 “x 2″ Acrylic Craft Squares
• Stamp Cleaner
• Paper
• Paint Pad (optional)
• acrylic paints or permanent ink pens
• Brush Finish
• Clear embossing ink pad
• glitter embossing powder
• Heat Gun Craft
• Paperboard (at least 2 “x 2″)
• Cutter
• mat cutter
• 1 / 4 “to 3 / 8″ Width sides Super-tape
• glitter or tiny glass beads
• magnetic tape
Gather the supplies listed above for this project. Use a permanent ink craft with a solvent-based ink solvent clean. Do not choose a stamp with the words, sounds like this project on the opposite side of the finished product, so any word would be backwards. square acrylic crafts can be purchased at a craft supply store or rubber stamp. The double-sided tape is sometimes called the super redline tape or adhesive tape. adhesive tape can be purchased in rolls in a discount store, and cuts easily with scissors or a knife.
Set up scrap paper to protect the work surface. Using a permanent ink, stamp image on acrylic square (if you have never used the first patch, try on a piece of paper). Immediately clean the stamp. Press the rubber stamp clean and dry with a paper towel. Repeat until the stain color on paper towels. Rub the rubber stamp on a clean, dry paint pad to remove any residue.
Color image printed with acrylic paint or use permanent ink pens. Let dry or heat in September
When the printed image is dry, pat the ink pad clear embossing with the printed image on the side. When completely covered, sprinkle glitter embossing powder. Remove the excess and return to tank embossing powder. Heat set the embossing powder with heat gun.
After the embossing powder is cooled, apply the tape on the edge of the acrylic square, keeping the board focused on the tape. Cut the tape so that all wraps around the square. Carefully on both edges while removing the protective film. Place the card on the mat. Place acrylic printed on card face down. Square Acrylic with holding hands, cutting cardboard with a knife. Cover the remaining tape exposed glass beads and tiny sequins, firmly. Heat all the glitter on the tape with heat gun. Then cut a piece of adhesive tape, remove the backing and stick on the back of the magnet.